Re: [Chrysler300] Dual Master Cylinder Conversion

[Bill Huff <czbill@xxxxxxxxxx>]

Thanks to those that responded to my questions.  It looks doable, 
since I don't have plug wire covers at this time their interference 
is not an issue.  However the MC that I was offered had the bail type 
top hold down, I don't think that will fly.  This is still in the 
planning stage, will post progress as it occurs.  I do have a 
question about the capacity of the MC should I decide to install disk 
brakes.  Most  MCs for disk brake systems have a much larger 
reservoir for the front disks.  I guess because the caliper pistons 
are so large.

Bill Huff



------------------------------------

To send a message to this group, send an email to:
Chrysler300@xxxxxxxxxxxxxxx

To unsubscribe from this group, send an email to bob@xxxxxxxxxxxxx or
go to http://autos.groups.yahoo.com/group/Chrysler300/join and select the "Leave Group" button

For list server instructions, go to http://www.chrysler300club.com/yahoolist/inst.htm

For archives go to http://www.forwardlook.net/300-archive/search.htm#querylangYahoo! Groups Links

<*> To visit your group on the web, go to:
    http://groups.yahoo.com/group/Chrysler300/

<*> Your email settings:
    Individual Email | Traditional

<*> To change settings online go to:
    http://groups.yahoo.com/group/Chrysler300/join
    (Yahoo! ID required)

<*> To change settings via email:
    Chrysler300-digest@xxxxxxxxxxxxxxx 
    Chrysler300-fullfeatured@xxxxxxxxxxxxxxx

<*> To unsubscribe from this group, send an email to:
    Chrysler300-unsubscribe@xxxxxxxxxxxxxxx

<*> Your use of Yahoo! Groups is subject to:
    http://docs.yahoo.com/info/terms/