Re: {Chrysler 300} Rebuild front wheel cylinders

["'pffkllc@xxxxxxx' via Chrysler 300 Club International" <chrysler-300-club-international@xxxxxxxxxxxxxxxx>]

I snayone making wheel cylinders other than the Chinese?  Are there any domestic makers anymore?

Pete Fitch

On Tuesday, September 9, 2025 at 05:52:45 PM EDT, David Dumais <ddume300@xxxxxxxxx> wrote:

Hello Club.

I installed a wheel cylinder kit in the front right side. I dropped DOT 3

Inside the center and assembled it. It was a new piece , the dust covers mushroomed out, with DOT 5 insystem..

All lines are flushed clean.

The rebuilt wheel cylinder pistons can be pushed in, firmly.

 Is this normal?

Prior to new kit install the pistons were able to be pushed in smoothly by finger action.

Thanks

Dave

--
For archives go to http://www.forwardlook.net/300-archive/search.htm#querylang
---
You received this message because you are subscribed to the Google Groups "Chrysler 300 Club International" group.
To unsubscribe from this group and stop receiving emails from it, send an email to chrysler-300-club-international+unsubscribe@xxxxxxxxxxxxxxxx.
To view this discussion visit https://groups.google.com/d/msgid/chrysler-300-club-international/CAJp4EVEG5o1%2BrSXMcjWtyab89S2bvxz041uVr9g_3a5fC4%3DX3A%40mail.gmail.com.

-- 
For archives go to http://www.forwardlook.net/300-archive/search.htm#querylang
--- 
You received this message because you are subscribed to the Google Groups "Chrysler 300 Club International" group.
To unsubscribe from this group and stop receiving emails from it, send an email to chrysler-300-club-international+unsubscribe@xxxxxxxxxxxxxxxx.
To view this discussion visit https://groups.google.com/d/msgid/chrysler-300-club-international/2083414997.1118729.1757511546231%40mail.yahoo.com.