Re: [Chrysler300] Need A Couple of Answers
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: [Chrysler300] Need A Couple of Answers



Hi Mike,
  To answer your transmission question first, 56-61 torqueflites did not
have a "park" position, when in neutral they will still roll. The emergency
brake is what keeps it from rolling. The brake is a drum on the back of the
transmission with small brake shoes inside.

 The horn wire that goes down the center of the steering column, connects to
a brass ring. This makes contact with a switch on the outside of the column.
The switch also has the directional canceling switch. The horn wire is
black. The quick fix would be to just un-plug the wire at the connector. The
steering column would need to be taken apart to get at the wire. I would
check the horn contact switch under the steering wheel cover first.

The exhaust elbows are not that hard to replace, the problem is that the
bolts tend to freeze in the manifolds and break when you try and remove
them. I would start soaking them (cold) with a penetrating oil like PB
blaster when you put it in winter storage, and keep them wet every couple of
weeks. By spring they may come right out. Gaskets are available from Bob
Merritt in the club news.

  To replace the PS shaft seal, the pulley must be removed first with a
special puller. The reservoir must also be removed from the pump so the
pulley can be pressed back on. The o-ring should also be replaced at this
time.

 When you try to start the car and it is dead, will the headlights come on?
If not, you have a large drain somewhere. Disconnect the negative cable to
the battery, and connect a test light between the post and the cable. If it
lights, there is a drain. Make sure the doors are shut, and all accessories
are off. If the headlights do come on, try shifting from neutral to 1st and
back to neutral. The neutral switch may be sticking. This will be the brown
wire coming up from the drivers side of the transmission. If it still won't
turn over, try grounding this wire. That will probably do the trick.
300ly,
    Don Verity
    Rhode Island
----- Original Message -----
From: Michael Reed <mrreed@xxxxxxxxxxxxxx>
To: <Chrysler300@xxxxxxxxxxxxxxx>
Sent: Friday, October 22, 2004 12:37 PM
Subject: [Chrysler300] Need A Couple of Answers




Although I've owned my 300F for nearly 26 years, it has been in a
museum for the last 21 years. I need to fix a few things, etc. At
the moment, I have the following questions I hope someone can help
me with;

-- Where does the horn wire exit the steering column? (have a bare
spot on it apparently, as the horn blows when turning the steering
wheels frequently).

-- How difficult is to replace the casting that's between the
exhaust manifold and the intake manifold heat chamber under the carb?

-- How difficult is to replace the power steering pump shaft seal?

-- (this seems like a silly question, but... I don't know the
answer -- only Chrysler product I've ever owned) When the
transmission is in neutral, is it a "park" mode? I.E. does it
prevent the car from rolling? It doesn't seem to...

Thanks for any help

Mike Reed
Lake Odessa, MI






To send a message to this group, send an email to:
Chrysler300@xxxxxxxxxxxxxxx

For list server instructions, go to
http://www.chrysler300club.com/yahoolist/inst.htm
Yahoo! Groups Links










------------------------ Yahoo! Groups Sponsor --------------------~--> 
Yahoo! Autos. Everything you need to know about buying 
or selling a car.  FREE Quotes, 360° Tours, Research,
Blue Book, Compare Vehicles, Buy Used
http://us.click.yahoo.com/kEZsdA/bwnGAA/YiGOAA/8LmulB/TM
--------------------------------------------------------------------~-> 

To send a message to this group, send an email to:
Chrysler300@xxxxxxxxxxxxxxx

For list server instructions, go to http://www.chrysler300club.com/yahoolist/inst.htm 
Yahoo! Groups Links

<*> To visit your group on the web, go to:
    http://groups.yahoo.com/group/Chrysler300/

<*> To unsubscribe from this group, send an email to:
    Chrysler300-unsubscribe@xxxxxxxxxxxxxxx

<*> Your use of Yahoo! Groups is subject to:
    http://docs.yahoo.com/info/terms/
 





Home Back to the Home of the Forward Look Network Archive Sitemap


Copyright © The Forward Look Network. All rights reserved.

Opinions expressed in posts reflect the views of their respective authors.
This site contains affiliate links for which we may be compensated.