RE: [Chrysler300] G vibration/grinding noise in rear
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

RE: [Chrysler300] G vibration/grinding noise in rear



Sounds like alot of time to tweak some pipes for clearance...... Most shops can custom fabricate a complete system, install it, and tweak it to clear everything in about 3 hours. Just sayin'.....

Ryan Hill 


 


To: Chrysler300@xxxxxxxxxxxxxxx; MRS954@xxxxxxx
From: brandt300g@xxxxxxxxx
Date: Tue, 26 Oct 2010 12:47:22 -0700
Subject: Re: [Chrysler300] G vibration/grinding noise in rear


  



Hello to Mark & all!
 
Yes Mark your right! I just got back from where Melissa was and the Dave from the other place remembers my exhaust pipes being a problem! Dumb me! What is really cool is that Dave from a 'little farther down Valley Center Road', specializes in Mufflers. After all, he is 'Valley Center Muffler'!!! Okay, enough.....he said my situation is about a half days work. I believe him because he explained to me that a pipe 'down at this section', cannot be fixed until, 'this other section of pipe', is fixed or moved away from frame, cross members, rear axle housing, etc.. ... Well, I'll be keeping you all informed. Thanks again Mark!! ;-D
 
Sincerely & 300ly, Brandt H J w/ a G.

--- On Tue, 10/26/10, Mark Souders <MRS954@xxxxxxx> wrote:

From: Mark Souders <MRS954@xxxxxxx>
Subject: Re: [Chrysler300] G vibration/grinding noise in rear
To: Chrysler300@xxxxxxxxxxxxxxx
Date: Tuesday, October 26, 2010, 4:36 AM

  

Brandt,
My guess is that your exhaust pipe is too close to something else underneath the car. Check you clearance between the pipes and tranny, crossmembers, driveshaft, shocks, gas tank, etc. My rule-of-thumb is if I can put a finger between the pipes and other surfaces, it's good to go. If not, when you "get on it" the flex of the driveline could close a gap and cause a vibration or rattle.

Mark Souders
300H
Mohrsville, PA

-----Original Message-----
From: Brandt Jimerson <brandt300g@xxxxxxxxx>
To: Chrysler300@xxxxxxxxxxxxxxx
Sent: Tue, Oct 26, 2010 12:59 am
Subject: [Chrysler300] G vibration/grinding noise in rear

Hello to all in 300sville!

ell, I finish brakes (doing them myself...successfully), then get the posi in 
ear (thanks Jeff, successful) except one wheel drags a little on full 
cceleration when first taking off, going around a corner. Is that normal!? 
. And now folks, the latest problem! Melissa is vibrating intermittenly (ugh), 
hen in both (D) drive and (N) nuetral and it sounds like it is coming from the 
ear. However, I'll bet my trans and/or engine mounts are gone and the engine 
unning is vibrating metal to metal and 'shooting the sound back to the rear'! I 
ad her make the noise again this time in nuetral so I set the parking brake, 
ent down along ground and listened, crawled along rear right around corner to 
assenger side where the rattling, clanking seemed more apparent in noise around 
he tranny/engine area. Is my theory perhaps correct here? Suggestions? Thanks 
ons in advane!!

incerely & 300ly, Brandt H J w/ a G.

[Non-text portions of this message have been removed]

------------------------------------
To send a message to this group, send an email to:
hrysler300@xxxxxxxxxxxxxxx
To unsubscribe from this group, send an email to bob@xxxxxxxxxxxxx or
o to http://autos.groups.yahoo.com/group/Chrysler300/join and select the "Leave 
roup" button
For list server instructions, go to http://www.chrysler300club.com/yahoolist/inst.htm
For archives go to http://www.forwardlook.net/300-archive/search.htm#querylangYahoo! 
roups Links
Individual Email | Traditional
http://docs.yahoo.com/info/terms/

[Non-text portions of this message have been removed]

[Non-text portions of this message have been removed]



 		 	   		  

[Non-text portions of this message have been removed]



------------------------------------

To send a message to this group, send an email to:
Chrysler300@xxxxxxxxxxxxxxx

To unsubscribe from this group, send an email to bob@xxxxxxxxxxxxx or
go to http://autos.groups.yahoo.com/group/Chrysler300/join and select the "Leave Group" button

For list server instructions, go to http://www.chrysler300club.com/yahoolist/inst.htm

For archives go to http://www.forwardlook.net/300-archive/search.htm#querylangYahoo! Groups Links

<*> To visit your group on the web, go to:
    http://groups.yahoo.com/group/Chrysler300/

<*> Your email settings:
    Individual Email | Traditional

<*> To change settings online go to:
    http://groups.yahoo.com/group/Chrysler300/join
    (Yahoo! ID required)

<*> To change settings via email:
    Chrysler300-digest@xxxxxxxxxxxxxxx 
    Chrysler300-fullfeatured@xxxxxxxxxxxxxxx

<*> To unsubscribe from this group, send an email to:
    Chrysler300-unsubscribe@xxxxxxxxxxxxxxx

<*> Your use of Yahoo! Groups is subject to:
    http://docs.yahoo.com/info/terms/



Home Back to the Home of the Forward Look Network Archive Sitemap


Copyright © The Forward Look Network. All rights reserved.

Opinions expressed in posts reflect the views of their respective authors.
This site contains affiliate links for which we may be compensated.