Re: [Chrysler300] Sudden drive train lock-up

["Ray Jones 1970hurst@xxxxxxxxx [Chrysler300]" <Chrysler300-noreply@xxxxxxxxxxxxxxx>]

Not really sure how your rear is assembled, but it sounds like the center pin has come loose in you spider gears and is hitting after one revolution of the tires/pinion. Go forward and it comes around and hits again.

Ray

On Sun, Nov 1, 2015 at 10:26 PM, Michael Moore mmoore8425@xxxxxxx [Chrysler300] <Chrysler300-noreply@xxxxxxxxxxxxxxx> wrote:

 

 When I backed it up, after approx 3 ft the drive locked up sharply, as though I had hit something. But I hadn’t,  and all 4 wheels were clear. It did the same thing going forward-locking up after just a few feet.I did this several times and the distances prior to lockup seemed the same.

I was able to give it a lot of gas and slowly it would move, but something was straining.

This afternoon, after completing new starter motor installation, I dropped the driveshaft to have a suspect rear U-joint replaced tomorrow, but I see nothing which looked like it was hitting.

On jack stands under the axle, I also am able to rotate both rear wheels in either direction continuously without a lock up. My next step is to remove both rear drums and ensure there are no  broken  brake springs, but if I don’t see anything there, I have no idea where to look next. There are no unusual noises when I rotate the wheels.

Any suggestions?

Thanks, MIke Moore

300H  

--

Ray Jones. Y'all come on down an see us. Ya hear?

__._,_.___

---

Posted by: Ray Jones <1970hurst@xxxxxxxxx>

---

To send a message to this group, send an email to:
Chrysler300@xxxxxxxxxxxxxxx

To unsubscribe from this group, send an email to bob@xxxxxxxxxxxxx or
go to https://groups.yahoo.com/neo/groups/all/manage/edit

For list server instructions, go to http://www.chrysler300club.com/yahoolist/inst.htm

For archives go to http://www.forwardlook.net/300-archive/search.htm#querylang

Visit Your Group

• Privacy • Unsubscribe • Terms of Use

__,_._,___