Re: [Chrysler300] On the road, again. 1964 Bulkhead connector question
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: [Chrysler300] On the road, again. 1964 Bulkhead connector question

Please send me pictures of the Gizmo that can help with  Bulkhead connectors, Thank in advance. My email is sa-noia@xxxxxxxxxxx  if you need it to send pictures.
Best Regards,
Stephen A. Noia
1-408-210-4736 cell

On Sunday, December 20, 2015 9:37 AM, "Greg Leggatt ggleggatt@xxxxxxxxx [Chrysler300]" <Chrysler300-noreply@xxxxxxxxxxxxxxx> wrote:

Since an undamaged bulkhead connector is very valuable today there is a cheap Napa tool to properly release these terminals. Email me and I'll send pics of it and it's application.


Sent from my iPad

On Dec 19, 2015, at 11:18 PM, 'Rich Barber' c300@xxxxxxx [Chrysler300] <Chrysler300-noreply@xxxxxxxxxxxxxxx> wrote:

This is a test of the emergency Chrysler 300 Club, International broadcast network.  640, 1240 Conelrad.  Bzzt, bzzt, bzzt.
I just re-upped and I’m checking to see if I can get back online with you and receive your pearls of wisdom.
A question on the bulkhead connector on the 1964 Chrysler 300K:  Is it possible to remove the terminals at the ends of the dash loom from the backside (passenger compartment side) of the bulkhead connector?  If so, is there a special tool or technique for removing these terminals without damaging them?
Rich Barber
Brentwood, CA


Posted by: Anna F Noia <sa-noia@xxxxxxxxxxx>

To send a message to this group, send an email to:

To unsubscribe from this group, send an email to bob@xxxxxxxxxxxxx or
go to

For list server instructions, go to

For archives go to

Visit Your Group
Yahoo! Groups
PrivacyUnsubscribeTerms of Use


Home Back to the Home of the Forward Look Network Archive Sitemap