Re: [Chrysler300] 1957,58,59 300 side ornamentation letter and number re
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: [Chrysler300] 1957,58,59 300 side ornamentation letter and number retention





You would think.


-----Original Message-----
From: 'Ron Waters' ronbo97@xxxxxxxxxxx [Chrysler300] <Chrysler300-noreply@xxxxxxxxxxxxxxx>
To: Chrysler300 <Chrysler300@xxxxxxxxxxxxxxx>
Sent: Fri, Jul 8, 2016 8:38 pm
Subject: Re: [Chrysler300] 1957,58,59 300 side ornamentation letter and number retention

 



I would think any auto body supply store would have clips that will do the job. They sell small packets of 5 or 6 that will either press on or cut a groove into the pin and spiral down until the letter is locked in place.
 
Ron
----- Original Message -----
Sent: Friday, July 08, 2016 8:29 PM
Subject: Re: [Chrysler300] 1957,58,59 300 side ornamentation letter and number retention

Marv,
    Try contacting Larry Jett.  I remember he was looking for a C on his side medallion that said good-bye on his Gaugin convertible years back.  Somehow he got the letter and affixed it so that he could sell it to Jeff Miklas!   By the way, when I replaced my side bezels, etc., I used the small fasteners and epoxied over them not for rattles but as insurance against what Larry had experienced.  To this day after driving my C I always glance at my side letters to see if they stayed with me or fled for a divorce!  I guess that is one of those subliminal issues that makes my pulse race when lifting the door to the storage garage when taking Mopsy out!   300’ly, Rob Kern
 
Sent: Friday, July 08, 2016 4:10 PM
Subject: [Chrysler300] 1957,58,59 300 side ornamentation letter and number retention
 
 

To any C, D or E members who have had to secure the numbers and letters to the side quarter plastic disc.  I have searched but have not been able to locate the small tinnerman like clips that hold the cast numbers and letter to the plastic red white and blue disc.  I can epoxy them but without some mechanical hold onto the pins I fear they will only break lose.  I have ordered numerous clips and push-ons but with so small a height to the pin I can't get any to hold.  Anyone else have a similar experience.  And thanks to all who responded to my last question.  Marv Raguse....57 and 58 300s...



__._,_.___

Posted by: mjraguse@xxxxxxx


To send a message to this group, send an email to:
Chrysler300@xxxxxxxxxxxxxxx

To unsubscribe from this group, send an email to bob@xxxxxxxxxxxxx or
go to https://groups.yahoo.com/neo/groups/all/manage/edit

For list server instructions, go to http://www.chrysler300club.com/yahoolist/inst.htm

For archives go to http://www.forwardlook.net/300-archive/search.htm#querylang





__,_._,___


Home Back to the Home of the Forward Look Network Archive Sitemap