Re: [Chrysler300] ....and now for a discussion or wheel bearing races
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: [Chrysler300] ....and now for a discussion or wheel bearing races

Bill Huff

At 03:49 PM 7/18/2016, 'Jack Boyle' jackcboyle@xxxxxxxxx [Chrysler300] wrote:

I just had my C300 front drums turned. The machinist noted that one inner and another outer race can be rotated in the hub by hand. I drove the car 2.000 miles last year with no problem ? lucky?

The bearings are only a few years old so I really donâ??t want to start over by looking for new(er) drums or hubs and new bearings again etc.

Anybody have any experience setting races in JB Weld or similar?.



Jack Boyle

(913) 544 4650

Enjoying the same C-300 since 1967

IMG_0623 small

[Non-text portions of this message have been removed]



Posted by: William Huff <czbill@xxxxxxxxxx>

To send a message to this group, send an email to:

To unsubscribe from this group, send an email to bob@xxxxxxxxxxxxx or
go to

For list server instructions, go to

For archives go to

Visit Your Group
Yahoo! Groups
PrivacyUnsubscribeTerms of Use


Home Back to the Home of the Forward Look Network Archive Sitemap