Re: [Chrysler300] Looking for parts! C-300
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: [Chrysler300] Looking for parts! C-300





If the 'choke tube cover' is that woven fiberglass stuff, it has been readily available in restoration specialties or through Corvette parts dealers as old 'vettes used it as well.


Larry Jett    When I was a boy, I was told that anybody could become President:  I'm beginning to believe it.
    Clarence Darrow


 
 

                                                                     



On Fri, Aug 5, 2016 at 10:20 AM, Keith Boonstra kboonstra@xxxxxxxxxxxx [Chrysler300] <Chrysler300-noreply@xxxxxxxxxxxxxxx> wrote:
 

Hi Josh,

I will have to look to make sure, but I think I have enough of the choke tube cover for you.

Keith Boonstra
-

On Thu, Aug 4, 2016 at 3:41 PM, josh@xxxxxxxxxx [Chrysler300] <Chrysler300-noreply@yahoogroups.com> wrote:
 

Hello Gentleman!


  I've been working on VIN# 1001 (1955 C300) every night for about a month now.  I'm getting everything in order since the car hasn't run in over 30 years.  I've disassembled, cleaned, scrubbed and soaked everything on the engine to remove 30 years of rust, Tennessee mud and grime.  I'm very close.  The original factory pumps are rebuilt and ready to go. All the valves and rings are now unstuck, moving freely and re-soaked.  What residue was in the engine has been cleaned and everything was coated in fresh MMO or motor oil.  All gaskets have been replaced and torqued down to factory spec.  I've still got a huge amount of work left, but it's moving along and of course I'm enjoying it.


  I've got a couple needs and wondered if anyone might be able to point me in the right direction???


  I need to find these:


Used:

1.) Rear 300 trunk emblem (not repro)

2.) Fan Shroud

3.) Spark plug washers (metal rings around grommets)

4.) Passenger side exhaust manifold


New:
1.) Proper spark plug wire set

2.) Correct material for choke tube cover

3.) Carb base gaskets



    Does anyone have any suggestions here? 




  Josh


  Cucamonga, CA





__._,_.___

Posted by: Larry Jett <larrywjett@xxxxxxxxx>


To send a message to this group, send an email to:
Chrysler300@xxxxxxxxxxxxxxx

To unsubscribe from this group, send an email to bob@xxxxxxxxxxxxx or
go to https://groups.yahoo.com/neo/groups/all/manage/edit

For list server instructions, go to http://www.chrysler300club.com/yahoolist/inst.htm

For archives go to http://www.forwardlook.net/300-archive/search.htm#querylang




Visit Your Group
Yahoo! Groups
PrivacyUnsubscribeTerms of Use

__,_._,___


Home Back to the Home of the Forward Look Network Archive Sitemap


Copyright © The Forward Look Network. All rights reserved.

Opinions expressed in posts reflect the views of their respective authors.
This site contains affiliate links for which we may be compensated.