|
Hi Val,
The handle itself has a lock screw that secures it to the regulator. You
can see it if you look down between the window fuzzy. Loosen it and remover the
rest of the screws, and you can pop off the panel. Then you can remove the
handle and bezel assembly. The rattling is likely caused by the rear window
guide more than anything else. The original covering comes off over time leaving
the window loose in the track. Gary Goers has the material for it. It needs to
be glued in place, and that can be a job in itself. I uses pieces of wood that
just fit inside the track, and a vise after the glue is applied. This makes sure
the material is all the way to the bottom of the track. Spray on upholstery
cement works best.
Hi All,
Going to replace the bushings and washers to stop the rattling of the front
windows when down. So here's the question: It appears you take out the screws of
the chrome grab piece and then slide up and over the door handle to facilitate
removing the trim panel ? Please advise.
Thanks,
Val Jeffers __._,_.___ Posted by: <dverity@xxxxxxxxxxx> To send a message to this group, send an email to: Chrysler300@xxxxxxxxxxxxxxx To unsubscribe from this group, send an email to bob@xxxxxxxxxxxxx or go to https://groups.yahoo.com/neo/groups/all/manage/edit For list server instructions, go to http://www.chrysler300club.com/yahoolist/inst.htm For archives go to http://www.forwardlook.net/300-archive/search.htm#querylang __,_._,___ |
Back to the Home of the Forward Look Network
Archive Sitemap