Re: [Chrysler300] Loosening nuts with a candle and lighter

["dan300f@xxxxxxx [Chrysler300]" <Chrysler300-noreply@xxxxxxxxxxxxxxx>]

Hi all:

 

I'm here in Japan freezing my tuckus off.  It's colder than a witches frasnarous!.

 

I tend to agree with John.  When I replace the pulley on the front of the crankshaft, I always put it in the oven for a bit and it slips on with no difficulty, therefore, with the heat expanding the metal, it should loosen the nut making it easy to remove it.

 

Dan Reitz

 

 

In a message dated 11/23/2016 10:12:04 A.M. Pacific Standard Time, jkg@xxxxxxxxxxxxxxxxx writes:

Someone light tell him about penetrating oil, which is wax already melted. If this works at all it is the heat on the nut....and the "oil" helping

__._,_.___

---

Posted by: DAN300F@xxxxxxx

---

To send a message to this group, send an email to:
Chrysler300@xxxxxxxxxxxxxxx

To unsubscribe from this group, send an email to bob@xxxxxxxxxxxxx or
go to https://groups.yahoo.com/neo/groups/all/manage/edit

For list server instructions, go to http://www.chrysler300club.com/yahoolist/inst.htm

For archives go to http://www.forwardlook.net/300-archive/search.htm#querylang

Visit Your Group

• New Members 1

• Privacy • Unsubscribe • Terms of Use

__,_._,___