Re: [Chrysler300] 62 Sport problem
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: [Chrysler300] 62 Sport problem





Hi John,
Thanks for the tip -missing problem corrected with a new condenser.
Lucky that I had a new US made one on hand.
Thanks again,
Doug

On October 28, 2018 at 2:24 PM John Grady <jkg@xxxxxxxxxxxxxxxxx> wrote:

Bad capacitor , the ones with rubber cone around wire in many “ new capacitor” box are junk . They do intermittent ,= weak spark . Best are old mopar with the flat copper strap . Do not throw those out unless positive they are no good. Which rarely happens   . All the same ,  6 or 12 does not matter . EE hat on . Be a sure the coil tower is spotless . Can arc over to two terminals there . 

Sent from my iPhone

On 28 Oct 2018, at 4:36 pm, doug warrener 2HsandaHeritage@xxxxxxxxxxx [Chrysler300] < Chrysler300-noreply@xxxxxxxxxxxxxxx> wrote:



Hi Group,

I need some expert input on my 62 sport conv misfiring or "stumbling". The car has the standard 413 and I have added the dual AFB's and a dual point distributor.

One year ago driving to and from the Ironstone Concours in Murphys, CA ( about 80 miles away) I experienced severe  misfiring.

Pulled all the plugs and found #2, #6 & #7 fouled with carbon deposits ( #2 by far the worst).

Replaced the plugs and thought the problem was solved. This year, drove to local shows and around my neighborhood with no problems.

The trip to the Ironstone Concours this year resulted in the same misfiring  problem.

Pulled all the plugs and only #2 had any carbon deposits.

Checked the compression and all cylinders at 150 +/-.

Checked and set point gaps, replaced the wire to #2 plug.

The engine runs ok with no load, but still misfires or "stumbles under load and at high speed.

The new plugs that I installed last year are Autolite A42B's which I believe are correct. However they may be 30years old or older. The cap and rotor are only a year or two old.

Could a defective coil cause the problem?

Thanks,

Doug Warrener 








 

__._,_.___

Posted by: doug warrener <2hsandaheritage@xxxxxxxxxxx>


To send a message to this group, send an email to:
Chrysler300@xxxxxxxxxxxxxxx

To unsubscribe from this group, send an email to bob@xxxxxxxxxxxxx or
go to https://groups.yahoo.com/neo/groups/all/manage/edit

For list server instructions, go to http://www.chrysler300club.com/yahoolist/inst.htm

For archives go to http://www.forwardlook.net/300-archive/search.htm#querylang




Visit Your Group
Yahoo! Groups
PrivacyUnsubscribeTerms of Use

__,_._,___


Home Back to the Home of the Forward Look Network Archive Sitemap


Copyright © The Forward Look Network. All rights reserved.

Opinions expressed in posts reflect the views of their respective authors.
This site contains affiliate links for which we may be compensated.