Re: {Chrysler 300} Packard 56 crimper

[John Grady <jkg@xxxxxxxxxxxxxxxxx>]

much better to strip and shape wires and terminal with piers and then solder, can shrink sleeve back too .   

Sent from my iPhone not by choice 

On 16 Jan 2021, at 5:21 pm, ALLAN POZDOL <apozdol@xxxxxxxxxxx> wrote:

Might anyone have a proper crimping tool for the Packard 56 terminals laying about in your toolbox that you might consider parting with?

 

I am replacing my bulkhead connectors as the red 12 ga. fried.

 

I have gone through three common "open barrel" crimpers and they are worthless in this application.

 

Allan

--
For archives go to http://www.forwardlook.net/300-archive/search.htm#querylang
---
You received this message because you are subscribed to the Google Groups "Chrysler 300 Club International" group.
To unsubscribe from this group and stop receiving emails from it, send an email to chrysler-300-club-international+unsubscribe@xxxxxxxxxxxxxxxx.
To view this discussion on the web visit https://groups.google.com/d/msgid/chrysler-300-club-international/777026596.90967.1610835689234%40connect.xfinity.com.

--
For archives go to http://www.forwardlook.net/300-archive/search.htm#querylang
---
You received this message because you are subscribed to the Google Groups "Chrysler 300 Club International" group.
To unsubscribe from this group and stop receiving emails from it, send an email to chrysler-300-club-international+unsubscribe@xxxxxxxxxxxxxxxx.
To view this discussion on the web visit https://groups.google.com/d/msgid/chrysler-300-club-international/F3999433-60A5-46BD-8896-1963568FE046%40gradyresearch.com.