Re: {Chrysler 300} Lift advice
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: {Chrysler 300} Lift advice



Not just 4 inches but should be 4 inches of 4000 pound concrete. Rebar is also a good idea. My two post sits on a 10' X 10' X 14" pad of 4000 lb concrete with 30" grid of .5 inch rebar. Not taking any chances!

On Wed, Nov 29, 2023 at 10:06 AM <dplotkin@xxxxxxxxxxxxxxxxxxx> wrote:

Good point!

4 post lifts need minimum 4" slab no anchors, 2 posts usually need more and must be anchored.

 

Danny Plotkin 

-----Original Message-----
From: "Marshall Larson" <granitledge@xxxxxxxxx>
Sent: Wednesday, November 29, 2023 11:02am
To: mguarneri@xxxxxxx
Cc: scotttaylorsc@xxxxxxxxx, chrysler-300-club-international@xxxxxxxxxxxxxxxx
Subject: Re: {Chrysler 300} Lift advice

In all the discussion on this topic, no one has mentioned anything about the floor you put your lift on. Make certain you have sufficient floor strength to handle the weight.

On Wed, Nov 29, 2023 at 9:02 AM mguarneri via Chrysler 300 Club International <chrysler-300-club-international@xxxxxxxxxxxxxxxx> wrote:
Scott, I picked up an Atlas lift about 5 years ago (see attached model manual).  I picked this one because it is oversize and would accommodate my two Chrysler's.  It is not bolted down and I have never used the post lifts to move it around.  In the attached picture I have my G conv on top with my '56 Windsor below.  
 
I have worked on both cars on this lift plus I have a 2012 Jeep Grand Cherokee 4x4 and had no problems size wise with the lift (I opted for the 110v motor).
 
Hope this helps in your decision.
John

In a message dated 11/28/2023 6:44:40 PM Eastern Standard Time, scotttaylorsc@xxxxxxxxx writes:
 
  For those of you with four post lifts that are not bolted down, how hard are they to move around?  Can one person do it? 
  We have a new three car garage at the house and I’m considering a couple of four post ones for storage… most likely with Chryslers on the ground and something lighter up top.  
  I want something with an electric lift, would prefer no air but have air available if needed.  Thinking about two, four post models but I’d like to not bolt them down if possible.  
 
Scott 

On Mon, Nov 27, 2023 at 8:31 PM Tom Wilburn <tomwilburn1@xxxxxxxxx> wrote:
I want to purchase a lift, and would appreciate advice.

While my preference would be an asymmetric chassis lift for maximum accessibility, I also want to use the lift for car storage.

So, I think that means a “drive on lift”, with accessories to allow wheel removal etc.

Any recommendations? 

I have no restrictions as this will be new construction.

Tom

Sent from my iPhone

--
For archives go to http://www.forwardlook.net/300-archive/search.htm#querylang
---
You received this message because you are subscribed to the Google Groups "Chrysler 300 Club International" group.
To unsubscribe from this group and stop receiving emails from it, send an email to chrysler-300-club-international+unsubscribe@xxxxxxxxxxxxxxxx.
To view this discussion on the web visit https://groups.google.com/d/msgid/chrysler-300-club-international/9801416C-A8E4-48D9-8FA7-D7BBF59E6EE9%40gmail.com.

 

--
For archives go to http://www.forwardlook.net/300-archive/search.htm#querylang
---
You received this message because you are subscribed to the Google Groups "Chrysler 300 Club International" group.
To unsubscribe from this group and stop receiving emails from it, send an email to chrysler-300-club-international+unsubscribe@xxxxxxxxxxxxxxxx.
To view this discussion on the web visit https://groups.google.com/d/msgid/chrysler-300-club-international/CANDych0M3azKGknWuL%3DD_WcTaoJ802aO136Aw0JdqYkoD_xoDA%40mail.gmail.com.
--
For archives go to http://www.forwardlook.net/300-archive/search.htm#querylang
---
You received this message because you are subscribed to the Google Groups "Chrysler 300 Club International" group.
To unsubscribe from this group and stop receiving emails from it, send an email to chrysler-300-club-international+unsubscribe@xxxxxxxxxxxxxxxx.
To view this discussion on the web visit https://groups.google.com/d/msgid/chrysler-300-club-international/1067086682.4581553.1701270134652%40mail.yahoo.com.

--
Marshall Larson
--
For archives go to http://www.forwardlook.net/300-archive/search.htm#querylang
---
You received this message because you are subscribed to the Google Groups "Chrysler 300 Club International" group.
To unsubscribe from this group and stop receiving emails from it, send an email to chrysler-300-club-international+unsubscribe@xxxxxxxxxxxxxxxx.
To view this discussion on the web visit https://groups.google.com/d/msgid/chrysler-300-club-international/CACuDFNQbrreaf4iCOEVYXvJU6CejrAU1DSgQvagoqxZ%2BXDNyxg%40mail.gmail.com.



 



--
Marshall Larson

--
For archives go to http://www.forwardlook.net/300-archive/search.htm#querylang
---
You received this message because you are subscribed to the Google Groups "Chrysler 300 Club International" group.
To unsubscribe from this group and stop receiving emails from it, send an email to chrysler-300-club-international+unsubscribe@xxxxxxxxxxxxxxxx.
To view this discussion on the web visit https://groups.google.com/d/msgid/chrysler-300-club-international/CACuDFNRxduNXwGkMBKPFbGOGfCzCqyDzZ1VCmUzOxx4RCzkhZw%40mail.gmail.com.


Home Back to the Home of the Forward Look Network Archive Sitemap


Copyright The Forward Look Network. All rights reserved.

Opinions expressed in posts reflect the views of their respective authors.
This site contains affiliate links for which we may be compensated.