Re: help with cable

[tom hecht <baddd65@xxxxxxxxx>]

on mine, the heavy cable goes over the top, around the
front of, then back under the starter (tucked against
the block) this gives it a straight shot to the
mounting bracket on the trans. 
i have a clip connected to a bolt on my oil pan that
can slip the cable into to keep it off the headers.
my cable is about an inch from the header and i have
had no problems.
my car had factory cable floor shifter, so i just fed
it through the factory hole in the floor.
this is 440, but a small block should be similar.

tom
65 satellite

--- Mike Shaw <bandsoperations@xxxxxxxxx> wrote:

> This is a little off subject, But I have a 74 duster
> 
> 360cu. and 727 trans.I installed a B&M hammer
> shifter,TTI headers. Putting the cable in is a night
> mare. I have two cables 8ft HD and the standard 5
> foot. Anyone been there done that.
> mike
> 



__________________________________________________
Do You Yahoo!?
Tired of spam?  Yahoo! Mail has the best spam protection around 
http://mail.yahoo.com