Re: still need transmission help

[HoustonDB@xxxxxxx]

Don't quote me on this, but I believe you have to remove the tailshaft  
housing.  Carl Monroe's 727 build says to remove the rear band apply  linkage by 
sliding the pivot pin rearward.  If you look at the tailshaft  housing, there 
should be a little nub on the front part of the housing that  is positioned near 
the pin.  This nub would effectively keep the shaft  from coming out if 
pushed to the rear.  If you removed the tailshaft, the  pin should ??? come out.  
 
I once had a shifty repair place cut the nub off on my original tailshaft  so 
they could replace the seal on the pin without removing the tailshaft  
housing.  But I wouldn't recommend that course of action......
 
Houston
'64 Belvedere



************************************** See what's free at http://www.aol.com.

[Non-text portions of this message have been removed]


----
Please address private mail -- mail of interest to only one person -- directly to that person.  I.e., send parts/car transactions and negotiations as well as other personal messages only to the intended recipient, not to the Clubhouse public address. This practice will protect your privacy, reduce the total volume of mail and fine tune the content signal to Mopar topic.  Thanks!

'62 to '65 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html.