Details, details

[Jim Jablonski <jim@xxxxxxxxxxxxx>]

Hi folks.  Hope everyone had a great 4th.

Putting the Fury back together after the paint job, and have a couple of 
miscellaneous questions:

- Does anyone know where I can find the tiny push nuts that hold the 
trunk spear onto the top of the trunk?  I can't find the ones I removed, 
and these are a bit smaller than most

- My new rear wiring harness has a plastic, rectangular-shaped clip on 
it, located about half-way up the inside of the left rear quarter.  
Interestingly, there is a bracket-like hole extending into the trunk 
opening  from the top of the left rear quarter, in approximately the 
same location as the clip in the harness.  It looks like the harness 
perhaps attaches to the bracket in some fashion.  Can someone look and 
perhaps send a pic or try to tell me what's going on there?

Any help is, as always, greatly appreciated

Thanks and regards,

Jim Jablonski
Royal Oak, Michigan
'64 Fury


----
Please address private mail -- mail of interest to only one person -- directly to that person.  I.e., send parts/car transactions and negotiations as well as other personal messages only to the intended recipient, not to the Clubhouse public address. This practice will protect your privacy, reduce the total volume of mail and fine tune the content signal to Mopar topic.  Thanks!

'62 to '65 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html.