RE: MAX WEDGE VICTOR HEADS

[Nick Tiberio <furyus63@xxxxxxxxxxx>]

Bob,

This summer I replaced my stock air filters with K&N filters and it 
raised the top of my air cleaners approximatley 1/8", it cleared. I then 
tried 1/4" gaskets under my carbs for heat insulation, no good.

My hood has all the hood framing cut out and contact was made on the 
engine's left front edge air cleaner. I just used some shaving cream on 
the top of the air cleaner and slowly came down with the hood.

So there was far less than the 1" you're looking for.

Nick Tiberio

63 Ply Fury
63 Ply Sport Fury





bigroberta@xxxxxxxxxxx wrote:
> 
> Hi all,
> 
> I mounted a set a victor heads on an old  440 block to see how a 
> crossram would look.
> 
> The crossram is raised about 1 in where the bottom of the intake meets 
> the block.
> 
> My question is. Will the air cleaners fit when the hood is shut?
> 
> Has anyone used this combo?
> 
> Robert
> 63 spt fury conv
> 63 spt fury http
> --
> [Non-text portions of this message have been removed]
> 



furyus63


----
Please address private mail -- mail of interest to only one person -- directly to that person.  I.e., send parts/car transactions and negotiations as well as other personal messages only to the intended recipient, not to the Clubhouse public address. This practice will protect your privacy, reduce the total volume of mail and fine tune the content signal to Mopar topic.  Thanks!

'62 to '65 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html.