I did not get in on the beginning of this,,,,,but am thinking he is going
from closed heads to open heads and there will be drastic CR change
In a message dated 7/11/2009 2:37:59 P.M. Central Daylight Time,
jake4@xxxxxxxxxx writes:
Herb,
Look at the part number on the heads, located either between the rocker
pads
or underneath on the head gasket side, the last three numbers you are
looking for are 452 or 346. If you have either set then go ahead and put
them on assuming they are in good condition, you will not run into any
issues.
Joey
----- Original Message -----
From: "Herb" <zephyr9900@xxxxxxxxxxx>
To: "1962 to 1965 Mopars" <1962to1965mopars@xxxxxxxxxx>
Sent: Saturday, July 11, 2009 1:24 PM
Subject: 400 Heads
Recently their was a discussions about the merits of the 400 heads. The
361
in my Sport Fury is in need of a valve job. As opposed to going
through
those heads and having the seats replaced and all the other machine work
needed for todays gas, would I be better off using a set of 400 heads
that
were just given to me saving $ in machine work? Or would I run into
compression or valve clearance problems?
Herb
1956 Plymouth Belvedere 361
1959 Coronet 326 Poly
1963 Fury 2D/HT 6.1
1963 Sport Fury Convertible 361
1970 Challenger RT 440
1999 Durango SLT 5.9
2006 300-C Heritage 5.7
2008 SRT-8 Magnum 6.1
St. Louis, MO.
http://1962to1965mopar.ornocar.com/mmo42009.html
[Non-text portions of this message have been removed]
----
Please address private mail -- mail of interest to only one person --
directly to that person. I.e., send parts/car transactions and
negotiations as well as other personal messages only to the intended
recipient, not to the Clubhouse public address. This practice will
protect
your privacy, reduce the total volume of mail and fine tune the content
signal to Mopar topic. Thanks!
'62 to '65 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html.
----
Please address private mail -- mail of interest to only one person --
directly to that person. I.e., send parts/car transactions and
negotiations as
well as other personal messages only to the intended recipient, not to
the
Clubhouse public address. This practice will protect your privacy, reduce
the total volume of mail and fine tune the content signal to Mopar topic.
Thanks!
'62 to '65 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html.
**************A Good Credit Score is 700 or Above. See yours in just 2
easy
steps!
(http://pr.atwola.com/promoclk/100126575x1221823300x1201398714/aol?redir=http://www.freecreditreport.com/pm/default.aspx?sc=668072&hmpgID=62&bcd=
JulystepsfooterNO62)
[Non-text portions of this message have been removed]
----
Please address private mail -- mail of interest to only one person --
directly to that person. I.e., send parts/car transactions and
negotiations as well as other personal messages only to the intended
recipient, not to the Clubhouse public address. This practice will protect
your privacy, reduce the total volume of mail and fine tune the content
signal to Mopar topic. Thanks!
'62 to '65 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html.