Re: parts needed to finish rebuild of A904 for slant 6

["Gary H." <62to65mopar@xxxxxxxxxxx>]

Just a double check to see that all the cap screws that hold the housing on are removed.  5?

Gary H.

>  -------Original Message-------
>  From: Roderek Soest  
>  
>  So I have bought the rebuild kit for it and have dissasembled it. The out put shaft endplay was 0.015 in. And I was wondereing if I need to buy new thrust washers. I know I need new rollers and springs for the sprag, and a reverse band. And I can't remove the tail shaft bearing, I took out the spring clip but it wont come out. Any answers to this question would be helpful. 

-- 
--
Please address private email -- email of interest to only one person -- directly to that person. That is, email your parts/car transactions and negotiations, as well as other personal messages, only to the intended recipient. Do not just press "reply" and send your email to everyone using the general '62-'65 Clubhouse public email address. This practice will protect your privacy, reduce the total volume of mail and fine-tune the content signal to Mopar topic. Thanks!

1962 to 1965 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html and http://www.1962to1965mopar.ornocar.com/general_disclaimer.html.
-- 
You received this message because you are subscribed to the Google Groups "The 1962 to 1965 Mopar Mail List Clubhouse" group.
http://groups.google.com/group/1962to1965mopars?hl=en.