Re: 64 440 k member

[Gary Futrell <gary.futrell@xxxxxxxxx>]

Andy,

  The torsion bars are larger in the V8 cars and they will
interchange. Since your car was a slant 6, I would probably change out
the K-member although Schumacher may have motor mounts that would work
with the big block. You can also install a later K-member such as a 69
or so that would move the engine back some and give better header
clearance. I think you can go with a K member up to 1970.

       Gary






On 10/8/06, The Mihalcheon's <ttak@xxxxxxx> wrote:
> Hello,
> I recently got a 64 440 2dr hardtop that used to be my Dads car 13 years ago. I want to put a 440 into the car it was a slant 6 model. I have a few questions .
> -Are the  torsion bars larger on the v8 cars ?
> - If so can i just replace them on my car ?
> - Or is it better for me to replace the whole k member ?
> - And if so what k member should i look for ?
> - What years k member will fit onto my car ?
> Thanks Andy
> [Non-text portions of this message have been removed]


----
Please address private mail -- mail of interest to only one person -- directly to that person.  I.e., send parts/car transactions and negotiations as well as other personal messages only to the intended recipient, not to the Clubhouse public address. This practice will protect your privacy, reduce the total volume of mail and fine tune the content signal to Mopar topic.  Thanks!

'62 to '65 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html. 

This email was sent to: arc.6265@xxxxxxxxxxxxxx

bSONJP. 
Or send an email to: 1962to1965mopars-unsubscribe@