RE: Oil filter shield

[Rich Kinsley <rlkinsley@xxxxxxxxx>]

I just took some and if I can figure it out I will do it. I always have 
a heck of a time getting pictures thru the net. 'Puter dummy!!
Rich Kinsley '64 Dodge Polara 4dr 318poly w/goodies
=====================================================================
roger@xxxxxxxxxxxxxxxxx wrote:
> 
> You going to post pics of the sheild?
> 
> ------Original Message------
> From: Rich Kinsley
> To: 1962to1965mopars@xxxxxxxxxx
> ReplyTo: 1962to1965mopars@xxxxxxxxxx
> Sent: Apr 6, 2009 8:39 PM
> Subject: Oil filter shield
> 
> 
> 
> 
> Rich Kinsley '64 Dodge Polara 4dr 318poly w/goodies
> 
> I finished the shield for my oil filter tonight. It looks great and 
> should work well. I have some insulating material that comes with 
> refrigeration fittings that is similar to asbestos in that it is used to 
> 
> shield the area around a fitting as it is brazed/soldered. I made the 
> aluminum shield to fit vertically from the engine about halfway around 
> the filter. I used weatherstrip adhesive to glue the material to the 
> inside of the heat shield so it was between the shield and the filter. 
> Then I secured it around the middle to the fillter with a big hose 
> clamp. It really looks nice and I gotta think it'll work fine. I needed 
> something as my TTI's made the fiter so hot it burned half the label off 
> 
> it. 
> 
> I didn't have room to pop rivet the shield to the clamp with spacers. I 
> tried but then I couldn't get it on the filter. Too tight an area.
> 
> Thanks for your ideas guys. 
> 
> 
> ----
> Please address private mail -- mail of interest to only one person -- 
> directly to that person.  I.e., send parts/car transactions and 
> negotiations as well as other personal messages only to the intended 
> recipient, not to the Clubhouse public address. This practice will 
> protect your privacy, reduce the total volume of mail and fine tune the 
> content signal to Mopar topic.  Thanks!
> 
> '62 to '65 Mopar Clubhouse Discussion Guidelines:
> http://www.1962to1965mopar.ornocar.org/mletiq.html. 
> 
> 
> 
> Sent via BlackBerry by AT&T



Rich Kinsley '64 Dodge Polara 4dr 318poly w/goodies


----
Please address private mail -- mail of interest to only one person -- directly to that person.  I.e., send parts/car transactions and negotiations as well as other personal messages only to the intended recipient, not to the Clubhouse public address. This practice will protect your privacy, reduce the total volume of mail and fine tune the content signal to Mopar topic.  Thanks!

'62 to '65 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html.