Re: Questions on priming
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: Questions on priming



Yes, I am turning counterclockwise on the 413.

Sent from my iPhone

On Oct 14, 2009, at 3:05 PM, Alex Ariemiea <ajaremea@xxxxxxxxxxx> wrote:


Are you turning the shaft in the counterclockwise direction? CCW for big blocks and CW for small block.




--- On Wed, 10/14/09, Layne G <64Polara500@xxxxxxxxx> wrote:


From: Layne G <64Polara500@xxxxxxxxx>
Subject: Re: Questions on priming
To: "1962to1965mopars@xxxxxxxxxx" <1962to1965mopars@xxxxxxxxxx>
Date: Wednesday, October 14, 2009, 1:54 PM


What would the culprits be if I'm not getting any oil pressure? What should I check? Any ideas would be helpful... Thanks all

Sent from my iPhone

On Oct 10, 2009, at 8:29 PM, Layne G <64Polara500@xxxxxxxxx> wrote:

We are trying to prime the engine using the priming shaft and drill. It's not turning.... Any ideas you can give me would be helpful...any other ways to prime the enigine that anyone would recommend? We know the engine turns.... Any thoughts, I would greatly appreciate!!!

Thanks again!
Layne
64 Polara 500
413 Rebuilt

--
[Non-text portions of this message have been removed]


----
Please address private mail -- mail of interest to only one person -- directly to that person. I.e., send parts/car transactions and negotiations as well as other personal messages only to the intended recipient, not to the Clubhouse public address. This practice will protect your privacy, reduce the total volume of mail and fine tune the content signal to Mopar topic. Thanks!

'62 to '65 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html.




Home Back to the Home of the Forward Look Network


Copyright © The Forward Look Network. All rights reserved.

Opinions expressed in posts reflect the views of their respective authors.
This site contains affiliate links for which we may be compensated.