Re: milling heads

[Stan Kafouse <skafouse@xxxxxxxxx>]

On an open chamber head every 10 off is 4 cc's. Usually they are way big and have to have a lot removed to get to factory  advertised cc. Closed chamber is roughly the same.

--- On Thu, 2/18/10, ed keaton <gtx69@xxxxxxx> wrote:


From: ed keaton <gtx69@xxxxxxx>
Subject: milling heads
To: "1962to1965mopars" <1962to1965mopars@xxxxxxxxxx>
Date: Thursday, February 18, 2010, 2:03 AM




Any one know for every 010 milled off is equal to how many cc's .How much off intake size of the head per 010 also?
[Non-text portions of this message have been removed]


----
Please address private mail -- mail of interest to only one person -- directly to that person.  I.e., send parts/car transactions and negotiations as well as other personal messages only to the intended recipient, not to the Clubhouse public address. This practice will protect your privacy, reduce the total volume of mail and fine tune the content signal to Mopar topic.  Thanks!

1962 to 1965 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html and http://www.1962to1965mopar.ornocar.com/general_disclaimer.html. 






--
[Non-text portions of this message have been removed]


----
Please address private mail -- mail of interest to only one person -- directly to that person.  I.e., send parts/car transactions and negotiations as well as other personal messages only to the intended recipient, not to the Clubhouse public address. This practice will protect your privacy, reduce the total volume of mail and fine tune the content signal to Mopar topic.  Thanks!

1962 to 1965 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html and http://www.1962to1965mopar.ornocar.com/general_disclaimer.html. 

This email was sent to: arc.6265@xxxxxxxxxxxxxx

u/?bUrDWg.bSONJP.YXJjLjYy



?p=TEXFOOTER