Re: Cone Strut Bushings VS. Donut -I'm stuck

[Eric R <hoodoovoodooray@xxxxxxxxx>]

Eh,  I just ordered Moog donut bushings, forget the cone style.   But
if anyone has info on using the cone type in place of the donut I'm
still interested. Thanks.

On Nov 9, 5:26 pm, Eric R <hoodoovoodoo...@xxxxxxxxx> wrote:
> '62 Newport had donut style front bushing.  New kit has cone type.
> PST says they are inter-changeable so use the cone.  Problem is, I'd
> have to compress the new cone bushing at lead 3/4" - 1"  to get the
> bolt holes on the strut rod to line up with the lower control arm.  I
> don't see how to do this with out the bushing eventually pulling
> through one side with that much pressure.
>
> Anyone else run into this situation?
>
> I have the cone bushings installed with the cone towards the back of
> the car.

-- 
--
Please address private mail -- mail of interest to only one person -- directly to that person. That is, send parts/car transactions and negotiations as well as other personal messages only to the intended recipient, not to the Clubhouse public address. This practice will protect your privacy, reduce the total volume of mail and fine tune the content signal to Mopar topic.  Thanks!

1962 to 1965 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html and http://www.1962to1965mopar.ornocar.com/general_disclaimer.html.
-- 
You received this message because you are subscribed to the Google Groups "The 1962 to 1965 Mopar Mail List Clubhouse" group.
http://groups.google.com/group/1962to1965mopars?hl=en.