Re: Brakes need pumped to work, why?
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: Brakes need pumped to work, why?



Your rear brakes have not been adjusted yet to factory specs.  Adjust them then give it a try, do you know how to adjust them?

On Wed, Feb 1, 2012 at 4:12 PM, Eric R <hoodoovoodooray@xxxxxxxxx> wrote:
I converted to AAJ discs. Used a 1976 Dart  dual master cylinder. No
leaks anywhere.

I bench bled the master cylinder best I could.

I bled the brakes using a hose and check valve into a jar of brake
fliud. This works on all my other vehicles.  I ran quite a bit of
fluid through to make sure.

Brake pedal goes straight to floor but will pump up quickly and hold
pressure.  As soon as I let up and pedal comes all the way to the TOP
the brakes are gone again and need to be pumped.  If I just let up a
little I don't lose them.

I then gravity bled them all for a few hours..  Two rears at same
time , then two front at same time.

Still get the same result.

I thought I read something about the Dart M/C  losing pressure
somehow?  Or, is it air in m/c?  Bad m/c?

Any advice is great ...  I would loooove to drive this car oneday.

--
--
Please address private mail -- mail of interest to only one person -- directly to that person. That is, send parts/car transactions and negotiations as well as other personal messages only to the intended recipient, not to the Clubhouse public address. This practice will protect your privacy, reduce the total volume of mail and fine tune the content signal to Mopar topic.  Thanks!

1962 to 1965 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html and http://www.1962to1965mopar.ornocar.com/general_disclaimer.html.
--
You received this message because you are subscribed to the Google Groups "The 1962 to 1965 Mopar Mail List Clubhouse" group.
http://groups.google.com/group/1962to1965mopars?hl=en.



--
Eric
Tacoma, WA
1962 Chrysler Newport 2 door HT

--
--
Please address private mail -- mail of interest to only one person -- directly to that person. That is, send parts/car transactions and negotiations as well as other personal messages only to the intended recipient, not to the Clubhouse public address. This practice will protect your privacy, reduce the total volume of mail and fine tune the content signal to Mopar topic. Thanks!
 
1962 to 1965 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html and http://www.1962to1965mopar.ornocar.com/general_disclaimer.html.
--
You received this message because you are subscribed to the Google Groups "The 1962 to 1965 Mopar Mail List Clubhouse" group.
http://groups.google.com/group/1962to1965mopars?hl=en.


Home Back to the Home of the Forward Look Network


Copyright © The Forward Look Network. All rights reserved.

Opinions expressed in posts reflect the views of their respective authors.
This site contains affiliate links for which we may be compensated.