Rear Hub Issue
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Rear Hub Issue



I re-bled the brakes using a Chrysler reccomended method and adjusted
the rears all the way in .  I gained pedal.

When I adjusted the rears to just a little drag I lost some pedal.
Quite a bit.  One side can be adjusted fine. The other can't.

I think the problem is the drivers side I can not adjust in very far
as when I spin the drum it sticks really bad in one spot.  Even with a
slight adjustment in it gets really hard to turn then once past that
spot it spins free-er until it hits it again. So I had to leave it
pretty loose.

If I could adjust that drum I'm pretty sure I'd gain pedal.

Warped drum?  I've read they don't make these drums anymore?

Guess I have to find the rare puller and try to take that drum off?

Here's one puller I found:  Good one? http://www.chrysler300club.com/rcmstuff/fairbanks/puller.html

-- 
--
Please address private mail -- mail of interest to only one person -- directly to that person. That is, send parts/car transactions and negotiations as well as other personal messages only to the intended recipient, not to the Clubhouse public address. This practice will protect your privacy, reduce the total volume of mail and fine tune the content signal to Mopar topic.  Thanks!

1962 to 1965 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html and http://www.1962to1965mopar.ornocar.com/general_disclaimer.html.
-- 
You received this message because you are subscribed to the Google Groups "The 1962 to 1965 Mopar Mail List Clubhouse" group.
http://groups.google.com/group/1962to1965mopars?hl=en.


Home Back to the Home of the Forward Look Network


Copyright © The Forward Look Network. All rights reserved.

Opinions expressed in posts reflect the views of their respective authors.
This site contains affiliate links for which we may be compensated.