PS Pump question

[Richard Kinsley <rlkinsley@xxxxxxxxx>]

After running my car with the ps pump belt removed for a couple days and raing at the track that way my ps pump is leaking badly at the front seal.

I can't imagine running without the belt would stress the pump in that area?  I took it off for two reasons. First it's pretty skitish at speed with that touchy PS.  Second I was afraid 7500rpm's might demolish it?  It's done OK at 6500rpm's for quite a few years.  I did run it up to those rpm's with it connected previously. 

Anybody got any ideas?  Just a fluke aka Murphy's Law?  I found a couple pumps listed at NAPA and O'Reilley's.  NAPA was NSP 816680 and O'Reilley was 20-6129.  I'm not sure which is correct but there's a better picture of O'Reilley's and it looked right. They are about $53 plus core w/res.. Actually w/o res was $6 higher at NAPA??

Rich Kinsley '64 Dodge Polara LeRoar 4dr 324 poly w/goodies

-- 
--
Please address private email -- email of interest to only one person -- directly to that person. That is, email your parts/car transactions and negotiations, as well as other personal messages, only to the intended recipient. Do not just press "reply" and send your email to everyone using the general '62-'65 Clubhouse public email address. This practice will protect your privacy, reduce the total volume of mail and fine-tune the content signal to Mopar topic. Thanks!
 
1962 to 1965 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html and http://www.1962to1965mopar.ornocar.com/general_disclaimer.html.
-- 
You received this message because you are subscribed to the Google Groups "The 1962 to 1965 Mopar Mail List Clubhouse" group.
http://groups.google.com/group/1962to1965mopars?hl=en.