Re: Installed Dual Master Cylinder

[Eric R <hoodoovoodooray@xxxxxxxxx>]

It sounded like someone was going to discs on the front.  If that's the case I used this proportiong valve succesfully.  Least expensive one I found.  http://www.jegs.com/i/JEGS+Performance+Products/555/63020/10002/-1

 

Oreilly's  ended up having the best selection of adapters around here.

 

You may also have to lengthen your m/c push rod.  That was a big improvement for me in pedal travel.   The size of the bore of your m/c has an effect as well. 

 

On Friday, November 30, 2012 4:27:11 PM UTC-5, 62to65mopar wrote:

> Visit the '62 - '65  tech page and search for the word disc. There are a half dozen or so links that provide part numbers and tips etc.  http://1962to1965mopar.ornocar.com/techstuff.html  Look in the top 25% of that page.
>
> Thanks,
> Gary H.
>
> >  -------Original Message-------
>
> >  
> >  I will be ordering a new M/C and new rotors, any suggestions? thanks
> >  Russell
> >  
> >

-- 
-- 
--
Please address private email -- email of interest to only one person -- directly to that person. That is, email your parts/car transactions and negotiations, as well as other personal messages, only to the intended recipient. Do not just press "reply" and send your email to everyone using the general '62-'65 Clubhouse public email address. This practice will protect your privacy, reduce the total volume of mail and fine-tune the content signal to Mopar topic. Thanks!
 
1962 to 1965 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html and http://www.1962to1965mopar.ornocar.com/general_disclaimer.html.
-- 
You received this message because you are subscribed to the Google Groups "The 1962 to 1965 Mopar Mail List Clubhouse" group.
http://groups.google.com/group/1962to1965mopars?hl=en.