I used stick epoxy its like putty and dries hard it is made by KBS and is called NuMetal. I was able to shape it into strips to repair the vents on the dash some of mine were broken. I also wraped it around the ducts where they had cracked. I used a dremel to clean them up.
On Wed, Feb 27, 2013 at 5:43 PM, Michael LeFevre
<493mike@xxxxxxxxx> wrote:
Hi fellas and gal,
Does anyone have words of wisdom concerning repair of the cracking plastic ducts that bolt to the dash?
Mike LeFevre
--
--
--
Please address private email -- email of interest to only one person -- directly to that person. That is, email your parts/car transactions and negotiations, as well as other personal messages, only to the intended recipient. Do not just press "reply" and send your email to everyone using the general '62-'65 Clubhouse public email address. This practice will protect your privacy, reduce the total volume of mail and fine-tune the content signal to Mopar topic. Thanks!
1962 to 1965 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html and http://www.1962to1965mopar.ornocar.com/general_disclaimer.html.
--
You received this message because you are subscribed to the Google Groups "The 1962 to 1965 Mopar Mail List Clubhouse" group.
http://groups.google.com/group/1962to1965mopars?hl=en.
---
You received this message because you are subscribed to the Google Groups "The 1962 to 1965 Mopar Mail List Clubhouse" group.
To unsubscribe from this group and stop receiving emails from it, send an email to 1962to1965mopars+unsubscribe@xxxxxxxxxxxxxxxx.
For more options, visit https://groups.google.com/groups/opt_out.
Back to the Home of the Forward Look Network