Re: Lug Nut Question on AP Torq Thrust-Style Wheels??
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: Lug Nut Question on AP Torq Thrust-Style Wheels??



I ran into the same problem when I put my Anson wheels on my car.  Studs too short.  Got longer studs at NAPA.  I couldn't find exactly the length I needed so bought longer ones and cut them off to length using a whizzer.  I used the acorn style nuts that came with the wheels. Made sure I left them long enough so 90% of the threads in the nut are engaged.  No problems in 3 years and several hundred miles.

Paul L. 

On Thursday, March 21, 2013 10:02:36 AM UTC-5, TorqueChap wrote:
Hi All,
Eager to mount a set of Torq Thrust wheels on my 300K Ram. But we're running into a safety issue.

The 1/2" diameter studs which are pressed into the hub and the drum aren't long enough. We've tried standard lugs (LH/RH) from Classic Industries but there just isn't enough bite to be safe. Research "suggests" that the set up should use acorn-style lugs and not sleeve-type.

As background, the wheels are early 1970s Torq Thrust-style units from Appliance Plating (AP) in 15x7.

Looking for information on how to safely mount these wheels on the 300. Safety is paramount and it's important that the wheels be firmly attached to the car (for obvious reasons!).

Many thanks for any and all advice/suggestions/leads!

David M.
New Jersey

--
--
--
Please address private email -- email of interest to only one person -- directly to that person. That is, email your parts/car transactions and negotiations, as well as other personal messages, only to the intended recipient. Do not just press "reply" and send your email to everyone using the general '62-'65 Clubhouse public email address. This practice will protect your privacy, reduce the total volume of mail and fine-tune the content signal to Mopar topic. Thanks!
 
1962 to 1965 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html and http://www.1962to1965mopar.ornocar.com/general_disclaimer.html.
--
You received this message because you are subscribed to the Google Groups "The 1962 to 1965 Mopar Mail List Clubhouse" group.
http://groups.google.com/group/1962to1965mopars?hl=en.
 
---
You received this message because you are subscribed to the Google Groups "The 1962 to 1965 Mopar Mail List Clubhouse" group.
To unsubscribe from this group and stop receiving emails from it, send an email to 1962to1965mopars+unsubscribe@xxxxxxxxxxxxxxxxx
For more options, visit https://groups.google.com/groups/opt_out.
 
 


Home Back to the Home of the Forward Look Network


Copyright © The Forward Look Network. All rights reserved.

Opinions expressed in posts reflect the views of their respective authors.
This site contains affiliate links for which we may be compensated.