|
A few years (10) back I would have questioned the price as well, but after
building my first maxwedge clone I do not, there is close to 4K sitting on top
of the engine, hard to tell by pictures of the quality, but there has been a lot
of body work done, and many extras are already finished( exhaust even if I do
not like it, frame connectors, front end rebuild, tubing, scoop, wheels, tranny
and probably rear end, just to mention a few), and the thought of it being
complete right down to the perforated headliiner,,,,,,,,,,, I really doubt that
many of us could buy a project and get it to this point for any less, and then
take into consideration that it is being sold by a car lot (extra
bucks),,,,,,,,,,,, just my 2 cents
-- -- -- Please address private email -- email of interest to only one person -- directly to that person. That is, email your parts/car transactions and negotiations, as well as other personal messages, only to the intended recipient. Do not just press "reply" and send your email to everyone using the general '62-'65 Clubhouse public email address. This practice will protect your privacy, reduce the total volume of mail and fine-tune the content signal to Mopar topic. Thanks! 1962 to 1965 Mopar Clubhouse Discussion Guidelines: http://www.1962to1965mopar.ornocar.org/mletiq.html and http://www.1962to1965mopar.ornocar.com/general_disclaimer.html. -- You received this message because you are subscribed to the Google Groups "The 1962 to 1965 Mopar Mail List Clubhouse" group. http://groups.google.com/group/1962to1965mopars?hl=en. --- You received this message because you are subscribed to the Google Groups "The 1962 to 1965 Mopar Mail List Clubhouse" group. To unsubscribe from this group and stop receiving emails from it, send an email to 1962to1965mopars+unsubscribe@xxxxxxxxxxxxxxxxx For more options, visit https://groups.google.com/groups/opt_out. |
Back to the Home of the Forward Look Network