We got our Belvedere out of winter hibernation today. We keep it at my buddy's place about 25 miles away from home. It fired right up like it had just run 5 minutes ago - after sitting since November. The new fuel pump I put in last year must have made a big difference. It ran like a top. When I put my foot on the brake pedal to shift it into gear, the pedal went to the floor. No pressure at all. We did a quick check of all of the lines, hoses, and wheel cylinders, and no signs of any leaks anywhere. We checked the master cylinder and it was almost empty, so we added fluid to the master cylinder and were able to get the pressure back up to normal. We topped it off and drove it home with absolutely no problems or change in pedal pressure. There wasn't even any air in the system as far as I could feel. Since it's a closed system, I'm puzzled as to where the fluid could
have gone without some kind of leak somewhere. Could it be that the seal on the master cylinder lid is shot and allowed the fluid to evaporate over the 5-6 months it was sitting? We haven't had this problem any other spring after storage. I haven't done a more thorough check yet, but the fact that the pedal was just fine the whole way home seems to indiate there aren't any hidden leaks. Anyone have a guess as to what happened?
Thanks,
Dave
'64 Belvedere 2DHT
318 Poly, Push Button Auto
--
--
--
Please address private email -- email of interest to only one person -- directly to that person. That is, email your parts/car transactions and negotiations, as well as other personal messages, only to the intended recipient. Do not just press "reply" and send your email to everyone using the general '62-'65 Clubhouse public email address. This practice will protect your privacy, reduce the total volume of mail and fine-tune the content signal to Mopar topic. Thanks!
1962 to 1965 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html and
http://www.1962to1965mopar.ornocar.com/general_disclaimer.html.
--
You received this message because you are subscribed to the Google
Groups "The 1962 to 1965 Mopar Mail List Clubhouse" group.
http://groups.google.com/group/1962to1965mopars?hl=en.
---
You received this message because you are subscribed to the Google Groups "The 1962 to 1965 Mopar Mail List Clubhouse" group.
To unsubscribe from this group and stop receiving emails from it, send an email to
1962to1965mopars+unsubscribe@xxxxxxxxxxxxxxxx.
For more options, visit
https://groups.google.com/groups/opt_out.
Back to the Home of the Forward Look Network