Re: 62 Chrysler question

["Gary H." <62to65mopar@xxxxxxxxxxx>]

As reported here by Nick T., for a 63 B and several years earlier the rear wheel studs that press into the hub and brake drum, NAPA Part # 641-1157 will work. The Wheel bolt is 169 1/2-20 x 1 5/8 inch.  May be another option. I don't know why these would not work on a 1962 Chrysler.

Thanks for the article. 

Gary H. 
 
>  -------Original Message-------
>  From: Eric Sturgis  
>  
>  Napa still has them.  On my car they are 641-1145 for the stud and 6412026
>  for the nuts.  I replaced all of mine so I don't have anymore Left
>  handed studs.  You just have to drill out and remove the broken studs and
>  replace them with the new ones.  Be sure to have them swedged.  Or you
>  can do the brake hub mod so you don't have to mess with it again.  

-- 
-- 
--
Please address private email -- email of interest to only one person -- directly to that person. That is, email your parts/car transactions and negotiations, as well as other personal messages, only to the intended recipient. Do not just press "reply" and send your email to everyone using the general '62-'65 Clubhouse public email address. This practice will protect your privacy, reduce the total volume of mail and fine-tune the content signal to Mopar topic. Thanks!

1962 to 1965 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html and http://www.1962to1965mopar.ornocar.com/general_disclaimer.html.
-- 
You received this message because you are subscribed to the Google Groups "The 1962 to 1965 Mopar Mail List Clubhouse" group.
http://groups.google.com/group/1962to1965mopars?hl=en.

--- 
You received this message because you are subscribed to the Google Groups "The 1962 to 1965 Mopar Mail List Clubhouse" group.
To unsubscribe from this group and stop receiving emails from it, send an email to 1962to1965mopars+unsubscribe@xxxxxxxxxxxxxxxxx
For more options, visit https://groups.google.com/groups/opt_out.