Re: sandblasting and a TorqueFlite?
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: sandblasting and a TorqueFlite?



I would wrap it & blast.  Dust and dirt can get in the bellhousing area if you have an engine covering the hole, or a plastic tarp wrapped around it!  I would change the front seal at some point as a CYA while I had it apart, blasting or not!
 
 
 
 
-------Original Message-------
 
From: Gary H.
Date: 9/2/2014 1:50:16 PM
Subject: sandblasting and a TorqueFlite?
 
Hi all,
 
A gent is working on a 1963 and asked for opinions. Any thoughts? Here are his concerns:
 
>>I  have the Dodge disassembled but I  still have the transmission in the car thinking I would cover it up...however, many guys think I should remove the trans. The car only  has 44,xxx miles, I thought leaving it in was the best approach. I cannot  see a rebuild needed. But guys tell me "remove the TorqueFlite: why risk getting sand in the transmission?" and speculate that even though the trans has low miles the seals are old and the rebuild is a good idea anyway.
 
 
 
 
--
--
--
Please address private email -- email of interest to only one person -- directly to that person. That is, email your parts/car transactions and negotiations, as well as other personal messages, only to the intended recipient. Do not just press "reply" and send your email to everyone using the general '62-'65 Clubhouse public email address. This practice will protect your privacy, reduce the total volume of mail and fine-tune the content signal to Mopar topic. Thanks!
 
1962 to 1965 Mopar Clubhouse Discussion Guidelines:
--
You received this message because you are subscribed to the Google Groups "The 1962 to 1965 Mopar Mail List Clubhouse" group.
 
---
You received this message because you are subscribed to the Google Groups "The 1962 to 1965 Mopar Mail List Clubhouse" group.
To unsubscribe from this group and stop receiving emails from it, send an email to 1962to1965mopars+unsubscribe@xxxxxxxxxxxxxxxx.
For more options, visit https://groups.google.com/d/optout.
 

--
--
--
Please address private email -- email of interest to only one person -- directly to that person. That is, email your parts/car transactions and negotiations, as well as other personal messages, only to the intended recipient. Do not just press "reply" and send your email to everyone using the general '62-'65 Clubhouse public email address. This practice will protect your privacy, reduce the total volume of mail and fine-tune the content signal to Mopar topic. Thanks!
 
1962 to 1965 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html and http://www.1962to1965mopar.ornocar.com/general_disclaimer.html.
--
You received this message because you are subscribed to the Google Groups "The 1962 to 1965 Mopar Mail List Clubhouse" group.
http://groups.google.com/group/1962to1965mopars?hl=en.

---
You received this message because you are subscribed to the Google Groups "The 1962 to 1965 Mopar Mail List Clubhouse" group.
To unsubscribe from this group and stop receiving emails from it, send an email to 1962to1965mopars+unsubscribe@xxxxxxxxxxxxxxxx.
For more options, visit https://groups.google.com/d/optout.


Home Back to the Home of the Forward Look Network


Copyright © The Forward Look Network. All rights reserved.

Opinions expressed in posts reflect the views of their respective authors.
This site contains affiliate links for which we may be compensated.