Motor & Trans Mounts
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Motor & Trans Mounts



Anyone used the Poly-Loc mounts? I'm concerned about their lack of vibration dampening ability. Anyone know if they make the Poly-Loc setup in rubber? They are also expensive. Standard rubber mounts are literally 1/10 the cost.

Also, does it make sense to run a torque strap if I'm using stock mounts? ala... www.engine-swaps.com/Pages/ProductsType/TorqueStraps.html I'm not going to run a HEMI, but I'm expecting my new motor to be over 400 HP.

Thanks

Bill M
65 Coronet 500 'vert http://goo.gl/6xUS1
73 Dart Sport, 05 Ram 2500 CTD, 4WD, QC, LB, Laramie
21 Model T Depot Hack, 06 Mazda 3

--
--
--
Please address private email -- email of interest to only one person -- directly to that person. That is, email your parts/car transactions and negotiations, as well as other personal messages, only to the intended recipient. Do not just press "reply" and send your email to everyone using the general '62-'65 Clubhouse public email address. This practice will protect your privacy, reduce the total volume of mail and fine-tune the content signal to Mopar topic. Thanks!
 
1962 to 1965 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html and http://www.1962to1965mopar.ornocar.com/general_disclaimer.html.
--
You received this message because you are subscribed to the Google Groups "The 1962 to 1965 Mopar Mail List Clubhouse" group.
http://groups.google.com/group/1962to1965mopars?hl=en.

---
You received this message because you are subscribed to the Google Groups "The 1962 to 1965 Mopar Mail List Clubhouse" group.
To unsubscribe from this group and stop receiving emails from it, send an email to 1962to1965mopars+unsubscribe@xxxxxxxxxxxxxxxx.
For more options, visit https://groups.google.com/d/optout.


Home Back to the Home of the Forward Look Network