RE: Water pump info
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

RE: Water pump info



Excellent!!!  You guys rock!

 

From: 1962to1965mopars@xxxxxxxxxxxxxxxx [mailto:1962to1965mopars@xxxxxxxxxxxxxxxx] On Behalf Of furyus63@xxxxxxxxxxx
Sent: Saturday, December 06, 2014 12:11 PM
To: 1962to1965mopars
Subject: Fwd: Water pump info

 

Poly Timing Cover & Water Pump Bolts

This information being provided by Richard Kinsley, forwarded by Nick Tiberio


 

Here are some pictures of the water pump with notations on bolt sizes. Note that the upper alt bracket bolt only attaches to the pump itself and can be fairly short. The lower alt bracket bolt is into the water jacket and must be sealed as with the corresponding bolt on the otherside. It doesn't hurt to put sealant on them all if you wish. I'd be prone to lean towards the long side on the bolts as there is room for them to enter the block without bottoming unless you really get carried away. All bolts are 3/8"X16 (3/8NC). The power steering bracket is a through bolt/nut only attached to the pump as with the upper alt bracket bolt.

 

I'd buy 3 ea 5", 1 ea 4", 1 ea 3", 1 ea 1&1/2" and 3 ea 1". You will also want a 3/8NC nut and washers for the bolts. I buy grade 8 for everything. Actually the bottom short bolts could probably be a bit longer than 1". I didn't have a spare front cover to check it with. Notice the location for the timing tab too. It uses those lower short bolts. This is with my '64 Dodge Polara. This water pump was the stock unit.

 

Rich Kinsley '64 Dodge Polara 4dr 318poly w/less goodies

 

 

 

--
--
--
Please address private email -- email of interest to only one person -- directly to that person. That is, email your parts/car transactions and negotiations, as well as other personal messages, only to the intended recipient. Do not just press "reply" and send your email to everyone using the general '62-'65 Clubhouse public email address. This practice will protect your privacy, reduce the total volume of mail and fine-tune the content signal to Mopar topic. Thanks!
 
1962 to 1965 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html and http://www.1962to1965mopar.ornocar.com/general_disclaimer.html.
--
You received this message because you are subscribed to the Google Groups "The 1962 to 1965 Mopar Mail List Clubhouse" group.
http://groups.google.com/group/1962to1965mopars?hl=en.

---
You received this message because you are subscribed to the Google Groups "The 1962 to 1965 Mopar Mail List Clubhouse" group.
To unsubscribe from this group and stop receiving emails from it, send an email to 1962to1965mopars+unsubscribe@xxxxxxxxxxxxxxxx.
For more options, visit https://groups.google.com/d/optout.

--
--
--
Please address private email -- email of interest to only one person -- directly to that person. That is, email your parts/car transactions and negotiations, as well as other personal messages, only to the intended recipient. Do not just press "reply" and send your email to everyone using the general '62-'65 Clubhouse public email address. This practice will protect your privacy, reduce the total volume of mail and fine-tune the content signal to Mopar topic. Thanks!
 
1962 to 1965 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html and http://www.1962to1965mopar.ornocar.com/general_disclaimer.html.
--
You received this message because you are subscribed to the Google Groups "The 1962 to 1965 Mopar Mail List Clubhouse" group.
http://groups.google.com/group/1962to1965mopars?hl=en.

---
You received this message because you are subscribed to the Google Groups "The 1962 to 1965 Mopar Mail List Clubhouse" group.
To unsubscribe from this group and stop receiving emails from it, send an email to 1962to1965mopars+unsubscribe@xxxxxxxxxxxxxxxx.
For more options, visit https://groups.google.com/d/optout.


Home Back to the Home of the Forward Look Network