Re: Tilt Steering Column

[carverex@xxxxxxx]

I second what Steve just said. The original "plunge joint" used by Ma Mopar was designed to absorb movement from frame flex which could fail the bearings in the steering column.

Good luck!

Lyle

63 Sport Fury 383

On Friday, December 12, 2014 3:32:23 PM UTC-5, sein...@xxxxxxxxxxx wrote:

Has anyone swapped their stock steering column for a Flaming River or Ididit tilt column?  Of course no one has one designed for a '64 B Body.  Flaming River has a Mopar Floor Shift Tilt Column, but I am not sure what length to get.  My car is away in storage or I could go measure it.  Any advice on a tilt column for power steering?
 
Thanks so much!
James
'64 Belvedere 9 passenger wagon


 

 

 

-- 
-- 
--
Please address private email -- email of interest to only one person -- directly to that person. That is, email your parts/car transactions and negotiations, as well as other personal messages, only to the intended recipient. Do not just press "reply" and send your email to everyone using the general '62-'65 Clubhouse public email address. This practice will protect your privacy, reduce the total volume of mail and fine-tune the content signal to Mopar topic. Thanks!
 
1962 to 1965 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html and http://www.1962to1965mopar.ornocar.com/general_disclaimer.html.
-- 
You received this message because you are subscribed to the Google Groups "The 1962 to 1965 Mopar Mail List Clubhouse" group.
http://groups.google.com/group/1962to1965mopars?hl=en.

--- 
You received this message because you are subscribed to the Google Groups "The 1962 to 1965 Mopar Mail List Clubhouse" group.
To unsubscribe from this group and stop receiving emails from it, send an email to 1962to1965mopars+unsubscribe@xxxxxxxxxxxxxxxx.
For more options, visit https://groups.google.com/d/optout.