RE: Heater Woes
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

RE: Heater Woes



Here is a photo from another 1965 Dodge "B"-- 
http://www.1962to1965mopar.ornocar.com/images/wickred1.jpg
If I recall correctly, the inlet hose is where an aftermarket reverse flush kit is installed, i.e., the red cap shown on the hose in this picture. Sound right? 

Gary H.


>  -------Original Message-------
>  From: Bill M 
>  I'm pretty sure I have them connected correctly. The port on the intake
>  goes to the heater control valve, and the port on the water pump goes to
>  the heater core. After much staring at the factory service manual, I
>  believe this is correct. Someone please tell me if I'm wrong.

-- 
-- 
--
Please address private email -- email of interest to only one person -- directly to that person. That is, email your parts/car transactions and negotiations, as well as other personal messages, only to the intended recipient. Do not just press "reply" and send your email to everyone using the general '62-'65 Clubhouse public email address. This practice will protect your privacy, reduce the total volume of mail and fine-tune the content signal to Mopar topic. Thanks!

1962 to 1965 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html and http://www.1962to1965mopar.ornocar.com/general_disclaimer.html.
-- 
You received this message because you are subscribed to the Google Groups "The 1962 to 1965 Mopar Mail List Clubhouse" group.
http://groups.google.com/group/1962to1965mopars?hl=en.

--- 
You received this message because you are subscribed to the Google Groups "The 1962 to 1965 Mopar Mail List Clubhouse" group.
To unsubscribe from this group and stop receiving emails from it, send an email to 1962to1965mopars+unsubscribe@xxxxxxxxxxxxxxxxx
For more options, visit https://groups.google.com/d/optout.


Home Back to the Home of the Forward Look Network