|
Collecting parts to assemble a 318 Poly short-block, that will be fresh from rebuild/balance. Already had the heads done a couple years ago, 3-way grind, manganese
bronze guides, positive lock stem seals. Should I replace the push rods? Recommended brand, part number? Anything else I am forgetting from this list below?
Other parts on the list, on hand or already replaced: 256 Schneider Cam, Gary P. Lifters, assembly lube Full gasket set, Fel-Pro Oil pump Oil pan, Milodon 30750 Brad Penn break-in oil Spin-on oil filter adapter, Canton Racing. K&N HP-3001 oil filter Fuel pump Motor mounts and tranny mount, Anchor Mopar Performance electronic distributor P3690426, plugs, wires Water pump, FlowKooler US Radiator, 1” tube aluminum “Desert Cooler” T-stat, Robertshaw Coolant, overflow tank, Stant cap, belts, hoses -- -- Please address private email -- email of interest to only one person -- directly to that person. That is, email your parts/car transactions and negotiations, as well as other personal messages, only to the intended recipient. Do not just press "reply" and send your email to everyone using the general '62-'65 Clubhouse public email address. This practice will protect your privacy, reduce the total volume of mail and fine-tune the content signal to Mopar topic. Thanks! 1962 to 1965 Mopar Clubhouse Discussion Guidelines: http://www.1962to1965mopar.ornocar.org/mletiq.html and http://www.1962to1965mopar.ornocar.com/general_disclaimer.html. -- You received this message because you are subscribed to the Google Groups "The 1962 to 1965 Mopar Mail List Clubhouse" group. http://groups.google.com/group/1962to1965mopars?hl=en. --- You received this message because you are subscribed to the Google Groups "The 1962 to 1965 Mopar Mail List Clubhouse" group. To unsubscribe from this group and stop receiving emails from it, send an email to 1962to1965mopars+unsubscribe@xxxxxxxxxxxxxxxx. For more options, visit https://groups.google.com/d/optout. |
Back to the Home of the Forward Look Network