Re: Opening Day at Norwalk

[mike creglow <mcreglow@xxxxxxxxx>]

don,

sorry to hear your car didn't improve. 
what rev limiter chip are you running in your 6AL?

if your fuel and ignition seem up to par, you may want to look at your valve train.

mike

On Sat, Apr 18, 2015 at 3:49 PM, Donald Gallimore <dongallimore@xxxxxxx> wrote:

Same results. Won't pull past 5200 RPM.  Ignition is all new.  Only thing I noted after the run was the timing after the run was at 40 deg advanced. Guess I did not reset it after I put on the MSD 6AL. 

Didn't make another run for various reasons.

Carb is about all I have left to pick on.  Plugs were right on or maybe a bit on the lean side if anything..Calling Compuflow in Medina this week for guidance.

Any ideas? 

 

Akron Don Gallimore

-- 
-- 
--
Please address private email -- email of interest to only one person -- directly to that person. That is, email your parts/car transactions and negotiations, as well as other personal messages, only to the intended recipient. Do not just press "reply" and send your email to everyone using the general '62-'65 Clubhouse public email address. This practice will protect your privacy, reduce the total volume of mail and fine-tune the content signal to Mopar topic. Thanks!
 
1962 to 1965 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html and http://www.1962to1965mopar.ornocar.com/general_disclaimer.html.
-- 
You received this message because you are subscribed to the Google Groups "The 1962 to 1965 Mopar Mail List Clubhouse" group.
http://groups.google.com/group/1962to1965mopars?hl=en.

--- 
You received this message because you are subscribed to the Google Groups "The 1962 to 1965 Mopar Mail List Clubhouse" group.
To unsubscribe from this group and stop receiving emails from it, send an email to 1962to1965mopars+unsubscribe@xxxxxxxxxxxxxxxx.
For more options, visit https://groups.google.com/d/optout.