Back to the original question. He has the stock 340 4 BBL cast iron manifold already. Is it worth the money and effort to swap it out, unless doing some serous drag racing? Thanks, Gary H. > -------Original Message------- > Anybody know if the edelbrock performer manifold for small block mopar > is a direct bolt on?? Or do u need taller throttle bracket, longer > cable etc kickdown etc..?? I have the stock 340 cast iron manifold on > right now, would it make any difference except for a little weight > loss and cool factor.?? > neal zimmerman, eugene oregon -- -- -- Please address private email -- email of interest to only one person -- directly to that person. That is, email your parts/car transactions and negotiations, as well as other personal messages, only to the intended recipient. Do not just press "reply" and send your email to everyone using the general '62-'65 Clubhouse public email address. This practice will protect your privacy, reduce the total volume of mail and fine-tune the content signal to Mopar topic. Thanks! 1962 to 1965 Mopar Clubhouse Discussion Guidelines: http://www.1962to1965mopar.ornocar.org/mletiq.html and http://www.1962to1965mopar.ornocar.com/general_disclaimer.html. -- You received this message because you are subscribed to the Google Groups "The 1962 to 1965 Mopar Mail List Clubhouse" group. http://groups.google.com/group/1962to1965mopars?hl=en. --- You received this message because you are subscribed to the Google Groups "The 1962 to 1965 Mopar Mail List Clubhouse" group. To unsubscribe from this group and stop receiving emails from it, send an email to 1962to1965mopars+unsubscribe@xxxxxxxxxxxxxxxx. For more options, visit https://groups.google.com/d/optout.