If I remember right, yes the Ball and Trunion of the \6 is smaller than the V8 counterpart, but all V8s used the same bigger Ball and Trunion version, whether 318 or more ci. Now, I'm remembering for a TorqueFlite, but assume 4-speed is likewise. Thanks, Gary H. > -------Original Message------- > > Hello guys. Just a quick question. I am wondering which driveshaft I need for my 63 Savoy. I have one but it's from the slant six three speed and the trunion flange is smaller than the 64 4 speed trans I am installing. Will a 318 shaft fit. Thank you for your time. -- -- -- Please address private email -- email of interest to only one person -- directly to that person. That is, email your parts/car transactions and negotiations, as well as other personal messages, only to the intended recipient. Do not just press "reply" and send your email to everyone using the general '62-'65 Clubhouse public email address. This practice will protect your privacy, reduce the total volume of mail and fine-tune the content signal to Mopar topic. Thanks! 1962 to 1965 Mopar Clubhouse Discussion Guidelines: http://www.1962to1965mopar.ornocar.org/mletiq.html and http://www.1962to1965mopar.ornocar.com/general_disclaimer.html. -- You received this message because you are subscribed to the Google Groups "The 1962 to 1965 Mopar Mail List Clubhouse" group. http://groups.google.com/group/1962to1965mopars?hl=en. --- You received this message because you are subscribed to the Google Groups "The 1962 to 1965 Mopar Mail List Clubhouse" group. To unsubscribe from this group and stop receiving emails from it, send an email to 1962to1965mopars+unsubscribe@xxxxxxxxxxxxxxxx. For more options, visit https://groups.google.com/d/optout.