The wiring manual is likely correct. The wire may have fallen off. Aren't the resisters mounted on the box? https://blog.drivenrestorations.com/2015/11/1968-1970-b-body-mopar-heater-box-with.html shows a later year B- body AC heater box restoration for inspiration. But here is a link for you to read. http://www.hotrod.com/articles/mopp-0311-1967-plymouth-valiant-heater-box-assembly/ Gary H. > -------Original Message------- > From: neal zimmerman > > Why does my manual show a ground wire from the heater box. I had none. > From where to where is it supposed to go? There WAS a dangling wire > attached to the w-shaped clip holding down the heater core tubes but > it was attached to nothing on the other end. > Thanks , > Neal -- -- -- Please address private email -- email of interest to only one person -- directly to that person. That is, email your parts/car transactions and negotiations, as well as other personal messages, only to the intended recipient. Do not just press "reply" and send your email to everyone using the general '62-'65 Clubhouse public email address. This practice will protect your privacy, reduce the total volume of mail and fine-tune the content signal to Mopar topic. Thanks! 1962 to 1965 Mopar Clubhouse Discussion Guidelines: http://www.1962to1965mopar.ornocar.org/mletiq.html and http://www.1962to1965mopar.ornocar.com/general_disclaimer.html. -- You received this message because you are subscribed to the Google Groups "The 1962 to 1965 Mopar Mail List Clubhouse" group. http://groups.google.com/group/1962to1965mopars?hl=en. --- You received this message because you are subscribed to the Google Groups "The 1962 to 1965 Mopar Mail List Clubhouse" group. To unsubscribe from this group and stop receiving emails from it, send an email to 1962to1965mopars+unsubscribe@xxxxxxxxxxxxxxxx. For more options, visit https://groups.google.com/d/optout.