Re: Gauge Problem on 1963 Dodge
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: Gauge Problem on 1963 Dodge



Limiter is bad. Points are stuck closed. Change the fuel gauge or have it repaired. He can also graft in an electronic regulator to replace the limiter. There are write ups on how to do this; it's slightly trickier for cars where it's built in to one of the gauges.

Dave Casey

On Aug 2, 2017 10:39 PM, <62-65-mail-list-club@xxxxxxxxxxx> wrote:

Hi all,

A Mopar fan I know through the 'net sent the following email (below) asking for tips. Any suggestions for him?

Thanks,
Gary H.

>  -------Original Message-------
 >> The gauges on my 1963 Dodge Custom 880 suddenly began to
>  >  peg out. I first noticed it a month or so ago after I changed to
>  >  non-ethanol gas, but I doubt that would have anything to do with
>  >  it???? My shop manual suggests the voltage limiter is the prime
>  >  suspect if both the temp and fuel gauges are not functioning properly.
>  >  (On my car, the voltage limiter is supposedly built into the back of
>  >  the fuel gauge.) But even the oil gauge pegs out. Any ideas on what
>  >  may have caused this, what to check, and/or remedies?


--
--
--
Please address private email -- email of interest to only one person -- directly to that person. That is, email your parts/car transactions and negotiations, as well as other personal messages, only to the intended recipient. Do not just press "reply" and send your email to everyone using the general '62-'65 Clubhouse public email address. This practice will protect your privacy, reduce the total volume of mail and fine-tune the content signal to Mopar topic. Thanks!

1962 to 1965 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html and http://www.1962to1965mopar.ornocar.com/general_disclaimer.html.
--
You received this message because you are subscribed to the Google Groups "The 1962 to 1965 Mopar Mail List Clubhouse" group.
http://groups.google.com/group/1962to1965mopars?hl=en.

---
You received this message because you are subscribed to the Google Groups "The 1962 to 1965 Mopar Mail List Clubhouse" group.
To unsubscribe from this group and stop receiving emails from it, send an email to 1962to1965mopars+unsubscribe@googlegroups.com.
For more options, visit https://groups.google.com/d/optout.

--
--
--
Please address private email -- email of interest to only one person -- directly to that person. That is, email your parts/car transactions and negotiations, as well as other personal messages, only to the intended recipient. Do not just press "reply" and send your email to everyone using the general '62-'65 Clubhouse public email address. This practice will protect your privacy, reduce the total volume of mail and fine-tune the content signal to Mopar topic. Thanks!
 
1962 to 1965 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html and http://www.1962to1965mopar.ornocar.com/general_disclaimer.html.
--
You received this message because you are subscribed to the Google Groups "The 1962 to 1965 Mopar Mail List Clubhouse" group.
http://groups.google.com/group/1962to1965mopars?hl=en.

---
You received this message because you are subscribed to the Google Groups "The 1962 to 1965 Mopar Mail List Clubhouse" group.
To unsubscribe from this group and stop receiving emails from it, send an email to 1962to1965mopars+unsubscribe@xxxxxxxxxxxxxxxx.
For more options, visit https://groups.google.com/d/optout.


Home Back to the Home of the Forward Look Network


Copyright © The Forward Look Network. All rights reserved.

Opinions expressed in posts reflect the views of their respective authors.
This site contains affiliate links for which we may be compensated.