Has anyone done a bolt-on EFI on an RB?

[JimJablonski <groovinjim@xxxxxxx>]

Hello good Mopar people,

I hope everyone is safe and well.

I'm contemplating a bit of re-work on my '64 Fury.  You may recall a few years back I built a 511 from an old motorhome block and powered it with two Edelbrock's on top of a CH-28 dual quad.  I'm thinking about bolting a dual quad EFI system on and looking at what's out there, e.g., Sniper, FAST, FiTech.  Has anyone done this and if so could you share your experiences and thoughts?

I haven't dug into this too far and I know these systems "self-tune," but I'm thinking I will want a setup that will let me tune some parameters myself ... the fuel and ignition tables at a minimum.

Thank you,

Jim

-- 
-- 
--
Please address private email -- email of interest to only one person -- directly to that person. That is, email your parts/car transactions and negotiations, as well as other personal messages, only to the intended recipient. Do not just press "reply" and send your email to everyone using the general '62-'65 Clubhouse public email address. This practice will protect your privacy, reduce the total volume of mail and fine-tune the content signal to Mopar topic. Thanks!
 
1962 to 1965 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html and http://www.1962to1965mopar.ornocar.com/general_disclaimer.html.
-- 
You received this message because you are subscribed to the Google Groups "The 1962 to 1965 Mopar Mail List Clubhouse" group.
http://groups.google.com/group/1962to1965mopars?hl=en.
--- 
You received this message because you are subscribed to the Google Groups "The 1962 to 1965 Mopar Mail List Clubhouse" group.
To unsubscribe from this group and stop receiving emails from it, send an email to 1962to1965mopars+unsubscribe@xxxxxxxxxxxxxxxx.
To view this discussion on the web visit https://groups.google.com/d/msgid/1962to1965mopars/79ff2804-6479-4ec5-bef8-83ed2a97177c%40googlegroups.com.