Vote for The Forward Look Network on the Mopar Top 100 Sites 
 


Re: balancer/pulley, straight six, PLEASE PLEASE HELP!!!!!!!!

From: Mark Flynn
Email: mark.a.flynn@intel.com
Date: March 24, 2001

Comments

If the crank main bolt won't thread then the pulley hub is probably not seated all the way on the shaft. I had the same problem with my Desoto. I thought the hub was all the way in based on the grease marks but the bolt wouldn't thread. did you use a vibration damper installer? if not Autozone rents them (free!). mine was a bear to install but after a lot of cuts and bruises I was able to muscle it on. Don't use a mallet as this could damage the crank or bearings.

Regards, Mark

 


Last changed: May 04, 2010