Vote for The Forward Look Network on the Mopar Top 100 Sites 


Motor mounts on a 318 Poly

From: George
Email: gsv@dakotacom.net
Remote Name: 199.46.200.237
Date: August 19, 2002

Comments

Alas I screwed up again and didn'y take a picture before I took the motor mounts off. I'm rebuilding a 318 in a 58' Belvedere. The part of the motor mount that bolts to the engine can be bolted on either toward the front or rear of the engine and this will make about a 1" difference in their location. I cannot find a clear detail in my manual as to which way they go in. Does anybody know? I am also wondering about the orientation of the rubber section of the mounts. The bolt is offset from the center. Is this supposed to go up, down, or sideways? Any info on this installation would be appreciated!

 


Last changed: May 04, 2010