Vote for The Forward Look Network on the Mopar Top 100 Sites 

Exhaust manifold woes..

From: Kelly
Email: ---
Remote Name:
Date: November 26, 2002
Time: 17:30:50


hey guys, I was repacking the front bearings in my dodge the other day, and as I looked into the engine compartment though the fenderwell, a crack in my drivers exhaust manifold greeted me. This puzzles me because the previous owner replaced the same one a few years ago. I checked the head and tailpipes, and there are no brackets missing. My question is are poly motors notorious for going through driver's side manifolds, or what I suspect, is that it could have possibly been torqued down too tight. Could I get this thing welded, or does anybody fabricate/make headers for it?? Thanks! Kelly


Last changed: May 04, 2010