Vote for The Forward Look Network on the Mopar Top 100 Sites 


lower control arm shaft

From: chuck lowe
Email: sprocketbuster@aol.com
Remote Name: 205.188.208.75
Date: September 23, 2003

Comments

when i reinstalled torsion bars and lower controll arm shaft i torqued shaft nut to factory specs--- 180 ft.lbs.---the inner is 100 ft.lbs.---the problem is---the crown nut is in beyond the kotter key---i can't remember if it was this way when i dismantled or not---there are no missing parts--- since i reinstalled weeks and weeks ago this question has been eating me up---passenger side is better than drivers side---frame is excellent---it has never been crashed---this has me stumped---will it create a problem---i would hate to shim out nut with washers---any and all help welcome---later---chuck lowe

 


Last changed: May 04, 2010